alaric378Contacts in the network : Myspace (no) , Facebook (no) |
Common electrical wiring mistakes you must avoid (2013-09-23)
Electric problems is something that we have do deal sooner or later. Our dependence on the electric appliances is to such an extent that a day problem can cause the disruptions in our daily routine. Do you often experience electricity related issues in your office or home. If it is so then your electrical wiring is faulty. In this article Electrical Rochester NY will highlight some of the most common electrical wiring mistakes that are been made.
The Junction boxes in your home or office protect the connections from accidental damage due to sparks, heat from a loose connection or short circuit. In short it prevents any sort of electrical mishap to occur. It is seen that the wires keep dangling from there. Electrical repair Rochester suggests that an electrical box is essential for accumulating and insulating wires in a safe manner. Ensure that the wires are of exact length as the wall or else it can be dangerous. Always have some extra or additional wire left there. It will not only protect from any mishap but will be of great use in future as well. Rochester Electrician says that unprotected plastic-sheathed cable is a serious issue. At times it can be observed that wires are exposed from the framing used which can be dangerous because of the wire which if is in reach of children, can lead to a big accident costing you even your kid’s life. Wire around the ceilings must be properly fitted since any loose connection can cause accidental damage.
Electrical Rochester NY says that loose switches or outlets not only bad, but even the worse condition is that they’re dangerous as well. Loosely connected outlets are not stable, causing the wires to loosen from the terminals. Loose wires can arc and overheat, creating a potential fire hazard. Cables are not protected unless it is provided support across the path. Make sure that you use appropriate number of clamps to avoid the dangling of wires and the frames would provide them space to insulate them. It is necessary that we have three-slot outlet which is properly grounded. We do get our two slot outlet replaced with three slot outlet to be able to use it for our three pin appliance. But we forget that when we switch to three slot outlet we also need to check for its ground wire. This can lead to electrical shocks. Electrician Rochester says that get the grounding of wire checked via testers available in the market to be on the safer end.
Don’t stuff too many wires into the box since that can cause dangerous overheating, short-circuiting and fire. The National Electrical Code specifies minimum box sizes to reduce this risk. Ensure that you better insulate the electrical boxes from the wall it’s installed on. It is required to prevent any damage that could be result of overheated wires or short circuit. Wire your GFCI (ground fault circuit interrupter) in a proper manner. These outlets protect you from a lethal shock by shutting off the power when they sense slight differences in current. There two pair of terminals, one pair, labeled “line,” is for incoming power for the GFCI outlet and the other set is labeled “load” which provides protection for downstream outlets. Rochester Electrician says that if you mix up the line and load connections you would end up losing the shock protection.
For professional Rochester Electrician call us at Marlock Electric, Inc!!!!
Become a fan